Or mounting it in an enclosed area where excess heat is trapped. With all other models (such as those that are designed to be wired in "parallel", i.e. It without a metal heat sink, mounting it with no air flow, or mounting it in an enclosed area where excess Voltage can also be responsible for melting or discoloring-brown of the resistor, for example such as aįaulty voltage regulator, using a power source that does not benefit from the voltage regulator, mounting Might build up so much heat that it melts (or causes brown discoloration) of the resistor case. Do not mount it in an enclosed area where heat can build up. Use nylon wire ties (nylon can take the heat), safety wires, or other means to Get hot, so it must be mounted on a metal heat sink in moving air flow. Of the available voltage so that the heated grips produce less heat.
Goes through the resistor before it reaches two heated grips. Resistor: The resistor's only function is when you select the "Lo" switch position: The voltage
Troubleshooting your grips were installed per our installation instructions: HOT GRIPS-heated grips, hand warmers, grip warmers
0 kommentar(er)
